Replica watches
atr-aeromorning-banner-accueil-698x96
enac-aeromorning-en
LHR_21-03_Aerospace_600x100
collins-aerospace
atr-aeromorning-banner-accueil-698x96
Collins
previous arrow
next arrow

Safran Helicopter Engines – Safran unveils Add+, an engine demonstrator built using 30% 3D-printed components

Safran Helicopter Engines - Safran unveils Add+

Paris Air Show, Le Bourget, 18 June 2019

Safran introduces Add+, an engine technological demonstrator with 30 % of its components made using additive manufacturing (3D-printed) techniques. The result of a partnership between several Safran companies, Add+ will enable 3D-printed parts to be used in Group production engines. Development started in early 2018 and assembly is now in progress. The demonstrator will be ground-run next autumn.

Etienne Hesse, R&T Project Manager and Add+ program coordinator at Safran Helicopter Engines says, “Add+ brings together additive manufacturing expertise from across the Safran group. We started work on an existing engine model and redesigned almost 30 % of its components using additive manufacturing techniques, with a view to integrating those components into serial production units. When we start ground runs, we will evaluate behavior of these new parts in operation”.

Based on an Arrius helicopter engine, Add+ evaluate major components made using Selective Laser Melting (SLM) techniques.

Since early 2018, experts have been working together at Safran’s facility in Bordes (Pyrénées-Atlantiques). Add+ makes use of additive manufacturing capabilities at Bordes, Saclay (Essonne) and Corbeil (Essonne).

Be the first to comment on "Safran Helicopter Engines – Safran unveils Add+, an engine demonstrator built using 30% 3D-printed components"

Leave a comment

Your email address will not be published.


*